Y-Strainer

Y-Strainers are devices for mechanically removing solids from flowing liquids or gases by means of a perforated or wire mesh straining element. They are used in pipelines to protect equipment such as pumps, meters, control valves, steam traps and regulators.

ConstructionCast, Forged and Fabricated
Types
Regular, Oversized
Sizes1/2″ onwards
Method
Cast
Forged
Fabricated		Material of Construction
Cast Iron, WCB (CS), SS (CF8, CF8M) etc
A105 (CS), SS, Ni Al Alloy
Carbon Steel, Stainless Steel- Austenitic & Duplex, Nickel Alloys
End connectionFlanged, Butt weld, Threaded, Bevel end, Socket weld
Mesh (of any material)Perforated Sheet / Wire Mesh and combination of these
SS, Duplex, Inconel or other special alloy steels as per customer
requirements.
AccessoriesP-tapping / Gauge
Drain / Vent valves
Coating / linings
Root valves

Key Features of LSI-MECH Y-Strainers

  • Efficient design for low cost
  • Compact end to end dimension
  • Suitable for vertical or horizontal mounting

Fabrication methods

  • Can be fabricated / Cast / Forged – as per customer requirement
  • In-house painting and packing facilities

Design specifications

  • Pressure drop at clean condition, at clogged condition and open area ratio/gross filtration area can be customized to customer requirements.
  • Machined screen seating area in the body for screen retention
  • Drain/blow off connection furnished with plug as standard (off centre / on centre)
  • Strainers meet ASME B16.5 & ASME B16.34 requirements
  • Blow-out gasket proof design for effective gasket sealing
  • Welders are qualified as per ASME Sec IX (if required)

Application

  • Process Industry
  • HVAC
  • Power Industry
  • Chemical Industry
  • Pharmaceutical Industry
  • Pulp and Paper Industry
  • Oil and Gas Industry
  • Metals and Mining Industry
  • Mineral Industry
  • Water and Waste Management
  • Fire Fighting Industry

Inspection & Testing Capabilities

  • Dye penetrant test
  • Hydrostatic/Hydraulic test
  • Vaccum test
  • Radiography
  • Ultrasound
  • Type test/ pressure drop test (additional cost for additional strainer)
  • Burst pressure test for strainer element (additional cost test)
  • PMI for SS parts
  • Charpy test for raw material
  • Any other test as per customer requirements.
Scroll to Top